1) i’ve encountered some issues with the fiber optic plate pressing too hard on the film and preventing eject for the first couple of pictures. It’s been a bit difficult to fix since it requires a lot of experimentation and had to print a lot of drafts at full resolution (.1mm layers), and that takes about 1.5 days from print start to the test. I’m getting very close. I was also sick for a bit, had a bit of unplanned travel, etc.
2) given all that, I am hoping/planning to ship the October 2021 orders mid next week (~December 14th).
3) I know i’m way over the estimate, my apologies. Should have beta tested this a bit more before release.
4) this of course allowed me to make a few other minor fixes, but yes, not an excuse.