Hasseblad Instax Square Back production delays (not that bad, and fixing it)

1) i’ve encountered some issues with the fiber optic plate pressing too hard on the film and preventing eject for the first couple of pictures. It’s been a bit difficult to fix since it requires a lot of experimentation and had to print a lot of drafts at full resolution (.1mm layers), and that takes about 1.5 days from print start to the test. I’m getting very close. I was also sick for a bit, had a bit of unplanned travel, etc.
2) given all that, I am hoping/planning to ship the October 2021 orders mid next week (~December 14th).
3) I know i’m way over the estimate, my apologies. Should have beta tested this a bit more before release.
4) this of course allowed me to make a few other minor fixes, but yes, not an excuse.

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.